Trillium 240 OBS to Pod Interposer

Document #:: LIGO-D0900651-v2
Document type:: D - Drawings

Other Versions:

LIGO-D0900651-v1
11 Feb 2010, 08:13

Abstract:: Trillium pod base flange to trillium interposer

Files in Document:

D0900651 Trillium Pod Interposer aLIGO BSC-ISI -V2.pdf (563.6 kB)

ICS/JIRA Record:

ICS_LINK

Topics:

Authors:

Keywords:: BSC-ISI

Notes and Changes:

- updated note on scribing
- updated the note on LIGO spec
- updated the revision block

************
(1) [the following is an email exchange with a machine shop (A. Stein):

//LIGO'S ANSWER...
Sent: Friday, June 4, 2010 11:11 AM

You’re right – the 4.10 dimension was accidentally referenced to the A-A section line. Go ahead with your plan, and use the dimensions from the model.

Thanks,
Andy//

//SHOP'S QUESTION...
Sent: Friday, June 04, 2010 11:02 AM
To: Andy Stein
Subject: D0900651-v2

Howdy Andy,

On the print there is a dimension of 4.10 to the letter “ W “, but that is to the section line of A-A, not to the center of the part. I am getting 4.00 to the center of part. Is this correct? My plan is to put that letter where the model shows, unless you want different.//]

************
(2) [the following is an email exchange with a machine shop (A. Stein):

//LIGO'S ANSWER...
Sent: Friday, May 28, 2010 11:52 AM

Yes, please include .02” chamfers around the .75”-diameter pads.

Also, please use the size from the model, for the “W” lettering. If it’s .274” tall in the model, go with that.

Thanks,
Andy//

//SHOP'S QUESTION...
Sent: Friday, May 28, 2010 11:45 AM
To: Andy Stein
Subject: D0900651-V2

Howdy Andy,

On this part there is a call-out for .02 chamfers on all sharp edges. Do you want the .75 dia pads chamfered as well? Also, note 6 asks for a 12 point letter “ W “. That is .125 tall according to my program, but the letter on the model is .274 tall. Which would you folks prefer?//]

Related Documents:

Referenced by:

LIGO Document D0900651-v2

Trillium 240 OBS to Pod Interposer