Trillium Pod Locating eccentric

Document #:

LIGO-D0901819-v2

Document type:

D - Drawings

Abstract:

Clamp eccentric used to hold Trillium pod against Alignment pins.

Files in Document:

• D0901819 Trillium pod Eccentric aLIGO BSC-ISI - V2.pdf (25.7 kB)

ICS/JIRA Record:

• ICS_LINK

Topics:

• Seismic Isolation
• Final Design

Authors:

• Sam Barnum

Keywords:

eccentric clamp trillium pod BSC-ISI

Notes and Changes:

- updated note on scribing
- updated the note on LIGO spec
- updated the revision block

************
[the following is an email exchange with a machine shop (A. Stein):

//LIGO'S ANSWER...
Sent: June 15, 2010 5:32 PM

The .53-diameter hole is for clearance. It doesn't need a flat bottom - you can go ahead and drill it, though please make sure the bottom edge of the .501/.502 section is free of burrs.

Yes, please add the .02 chamfer to both ends of the hole, as well as the hex end.

Thanks,
Andy//

//SHOP'S QUESTION...
Sent: June 15, 2010 4:01 PM
To: Andy Stein
Subject: D0901819-V2

Howdy Andy,

On this part, I would like to drill the .53 dia. It looks like it is for clearance, but does it need to have a flat bottom? Also, the hole from either side doesn’t show any chamfering. I was going to add the usual .02 chamfer to both ends of the hole and the hex end. Sound good?//]

Related Documents:

Referenced by: