aLIGO HEPI L1 ETMX (BSC4) Assembly Validation Report

Document #:

LIGO-E1300931-v1

Document type:

E - Engineering documents

Abstract:

This document summarizes the tests done to validate the HEPI L1 ETMX (BSC4) assembly and installation. As all L1 HEPI BSC, it had been installed since 2004 at Livingston. However, it had been grounded for the 2 to 3 years of aLIGO install. All electronics have been updated since, and more importantly, the position of the ETMX support tubes (i.e. the position of the 4 HEPI ETMX boots), but not the one of the housings, was adjusted before ISI installation to accommodate for Initial Alignment needs. HEPI was initially kept locked for the 1st few months of use the X-arm. In order to allow for further adjustment of the optics position, HEPI was released on March 31st 2014. All tests were completed by the end of April 2014.

Files in Document:

• E1300931 aLIGO HEPI L1 ETMX Assembly Test Report -v1.pdf (1.7 MB)

Other Files:

• E1300931 aLIGO HEPI L1 ETMX Assembly Test Report -v1.docx (956.6 kB)

Topics:

• Subsystem Test
• Seismic Isolation

Authors:

• Celine Ramet

Notes and Changes:

Preliminary version, still incomplete.

Related Documents:

• LIGO-E1300824: aLIGO HEPI Assembly Validation Procedure

Referenced by:

• LIGO-E1300454: aLIGO HEPI Testing Reports